Still have a SonicWall Gen 6 at a branch, on an internet edge, or running as a virtual appliance? Put its replacement on the vulnerability queue. SonicWall’s November 18, 2026 advisory calls for retiring Gen 6 and Gen 6.5 firewalls and removing them from the internet edge.

Advisory kA1VN000002iouP0AQ, published November 18, 2026. Last verified November 22, 2026. SonicWall classifies units still in service as a high-risk exposure and says it will issue no further firmware or security patches for Gen 6, even for critical vulnerabilities. The notice has no new CVE or CVSS score.
Which devices to check
The guidance covers Gen 6 and Gen 6.5 firewalls running SonicOS 6.x, including Gen 6 NSv virtual firewalls. Use the vendor’s model table to check TZ, SOHO, NSA/NSa, SuperMassive, NSsp and NSv inventory. The vendor prioritizes equipment with internet exposure, SSL VPN or WAN management.
SonicWall expects internet-facing Gen 6 units to be targeted. The November 18 notice reports no new incident or confirmed exploitation. It cites historical SonicOS CVE-2024-40766, which CISA added to KEV on September 9, 2024. The federal remediation deadline for that historical CVE was September 30, 2024. This retirement advisory has no new KEV entry or federal deadline.
What to do
Suggested MSP priority Urgent for verified internet-facing units, especially those providing remote access. Plan retirement for the remaining Gen 6 and 6.5 inventory.
- Inventory. Check physical and virtual units, spares, model, firmware, WAN management, SSL VPN and dependent tunnels. Start with internet-facing and remote-access deployments.
- Reduce exposure until cutover. SonicWall advises disabling WAN HTTPS, SSH and SNMP management, disabling SSL VPN or limiting it to known source addresses, enforcing MFA on remaining remote-access and admin accounts, resetting local passwords, disabling unused services and interfaces, and monitoring unusual logins, configuration changes and traffic. These controls reduce exposure while replacement is pending.
- Replace. Move to a supported Gen 8 model running SonicOS 8. SonicWall’s applicable physical migration guide lists SonicOS 6.5.4.14 or later as a source requirement and points to the NSM Migration App for VLAN or tunnel interfaces. That source version is a migration prerequisite. Follow the separate Gen 6 NSv to Gen 8 NSv guide for supported virtual deployments.
- Verify. Test intended admin access, MFA, VPNs, routing, NAT and firewall policies on the replacement. Confirm monitoring and backups and remove the old appliance from production.